01
SW Premium Durable Grammer 90.3 Airbag Pneumatic Waist Support Adjustment Kit for Trucks (OE:0009104638/1)
PRODUCT DESCRIPTION
An in-car air bag is a safety device designed to protect passengers in a vehicle collision. They are usually installed on the vehicle's steering wheel, dashboard, seats, doors, etc. When a vehicle is involved in a collision, air bags inflate rapidly to reduce the likelihood of injury to passengers.
Air bag support systems usually consist of sensors, control units and inflators. The sensor will monitor the collision of the vehicle. Once a collision is detected, the control unit will quickly trigger the inflator to inflate the airbag quickly. When an air bag inflates, it supports and protects passengers in a crash, reducing the risk of head and chest injuries.
Remove, install
4 Open the zipper at the back of the backrest cover (3).
5 Remove the backrest cover (3) to the left and right of the foam part (4).
6 Disconnect the upper chamber compressed air hose (8) and the lower chamber compressed air hose (7) from the hose connectors
7 Remove the cable ties (6) and remove the lumbar support (5) upwards between the grid frame and the foam part (4).
8 Installation is carried out in reverse order.
Removing, installing
5 Roll the backrest cover up.
6 Mark the locations where the compressed air hoses (4 and 11) for the side contour adjustment chambers (5 and 12) are attached with cable ties (6).
7 Remove cable ties (6).
8 Side contour adjustment, left (5):
8.1 Carefully detach the foam part (3) from the backrest frame (7) in the area of the left chamber.
Installation instructions:
Glue the foam part (3) and backrest frame (7) to the existing adhesive points using Dunlop upholstery adhesive or equivalent adhesive.
8.2 Drill out the rivet heads of the two blind rivets (8) and remove them with washers (9).
8.3 Remove the compressed air hose (4) from the hose connector (10) and remove the left side contour adjustment (5) from the backrest frame (7).
9 Side contour adjustment, right (12):
9.1 Carefully detach the foam part (3) from the backrest frame (7) in the area of the right chamber.
Installation instructions:
Glue the foam part (3) and backrest frame (7) to the existing adhesive points using Dunlop upholstery adhesive or equivalent adhesive.
9.2 Drill out the rivet heads of the two blind rivets (8) and remove them with washers (9).
9.3 Remove the compressed air hose (11) from the hose connector (10) and remove the right side contour adjustment (12) from the backrest frame (7).
10 Installation is carried out in reverse order.